Table of Contents
Advertisement
SET UP THERMO / HYGRO SENSOR (RTGR368N)
1.
Open the battery compartment with a small Phillips
screwdriver.
2.
Insert the batteries.
3.
Set the channel and radio signal format. The
switches are located in the battery compartment.
SWITCH
OPTION
Channel
If you are using more than
one sensor, select a
different channel for each
sensor.
Radio Signal Format
EU (DCF) / UK (MSF)
4.
Press RESET. Then set the temperature unit.
SWITCH
OPTION
Temp
°C / °F
5.
Close the battery compartment.
To fold out the stand:
For best results:
•
Insert the batteries and select the unit, channel, and
radio signal format before you mount the sensor.
•
Place the sensor out of direct sunlight and moisture.
•
Do not place the sensor more than 70 metres (230
feet) from the main (indoor) unit.
•
Position the sensor so that it faces the main (indoor)
unit, minimizing obstructions such as doors, walls,
and furniture.
•
Place the sensor in a location with a clear view to
the sky, away from metallic or electronic objects.
•
Position the sensor close to the main unit during
cold winter months as below-freezing temperatures
may affect battery performance and signal
transmission.
NOTE The transmission range may vary and is subject
to the receiving range of the main unit.
12
To use the wall mount:
Advertisement
Table of Contents
