Getting Started; Batteries; Ac Adaptor (Main Unit); Change Settings - Oregon Scientific BAR933HG User Manual

GETTING STARTED

BATTERIES

Batteries are supplied with this product:
• Main unit
• Remote unit
Insert batteries before first use, matching the polarity
as shown in the battery compartment. For best results,
install batteries in the remote sensor before the main
unit. Press RESET after each battery change.
To install the main unit batteries:
Do not use rechargeable batteries.
NOTE
NOTE It is recommended that you use alkaline
batteries with this product for longer performance.
shows when batteries are low.
UNIT LOCATION
Main Temperature / Humidity Area
(when indoor data is displayed)
Temperature / Humidity Area
Remote
UVI / Barometric Pressure Area
UV Sensor

AC ADAPTOR (MAIN UNIT)

The batteries serve as a back-up power supply. For
continuous use, please install the AC adaptor at the base
of the unit:
shows in the Message Display Area when the AC
adapter is not plugged in.
4 x UM-4 (AAA) 1.5V
2 x UM-3 (AA) 1.5V

CHANGE SETTINGS

1. Press SELECT to switch between Areas.
indicates the selected Area.
2. Most Areas have alternate display options (for
example, Clock / Alarm or Barometer / UVI). Press
MODE to switch options, or ALARM /
between clock and alarm.
3. Press and hold MODE for 2 seconds to enter setting
mode.
4. Press UP or DOWN to change settings.
5. Press MODE to confirm.

REMOTE SENSOR

This product is shipped with the RTGR368N Thermo /
Hygro Sensor. The main unit can collect data from up to
6 sensors (5 Thermo / Hygro Sensors and 1 UV Sensor).
The THGR328N and THGR228N sensors are also
compatible with this weather station. (Additional sensors
are sold separately. Contact your local stockist for more
information.)
The RTGR368N sensor collects temperature and
humidity readings, and signals from official time-keeping
organizations for the radio-controlled clock.

SET UP THERMO / HYGRO SENSOR (RTGR368N)

1. Open the battery compartment with a small Phillips
screwdriver.
2. Insert the batteries.
3. Set the channel and radio signal format. The switches
are located in the battery compartment.
SWITCH
Channel
Radio Signal Format
4. Press RESET. Then set the temperature unit.
SWITCH
Temp
5. Close the battery compartment.
5
to switch
OPTION
If you are using more than one
sensor, select a different
channel for each sensor.
EU (DCF) / UK (MSF)
OPTION
°C / °F