Licensing Information - Shure UHF-R MW User Manual

Shure UHF-R MW Wireless
®
Architects' and Engineers' Specifications
The wireless system shall operate in the UHF band between 779-932 MHz, with the specific range being dependent on the user's
locale. The system shall include the option of changing the operating frequency in order to avoid RF interference, enabling up to 39
systems to operate simultaneously in the same location. Preconfigured group, channel and frequency setups shall be available to
ensure that multiple systems in use do not interfere with one another.
All transmitters shall be powered by 2 AA batteries and shall have a power on/off switch. The bodypack will have an LED indicating that
power is on. Available transmitters shall include: a body pack for use with electric guitars, basses, and other electric instruments, and
a handheld microphone for vocals. The transmitters shall have a DC/DC converter to ensure consistent performance, even if battery
voltages change.
The receiver shall have a user-programmable, menu-driven LCD showing group, channel, frequency, name, squelch level, and locked/
unlocked status. The system shall use technology such as MARCAD‚ signal combining circuitry to improve reception, minimize signal
dropouts, and achieve the best possible signal-to-noise ratio. An equalizer, tone key squelch, and noise squelch circuitry shall be built
into the system to provide optimal sound quality and minimize unwanted noise. The receiver shall include dual RF meters (one for each
antenna), an audio level meter, and a Networking Interface connector for computer control and monitoring. The receiver shall have a
volume control and an adjustable noise squelch control.
The system shall be the Shure UHF-R
Emission Designator
120KF3E
The "EU Declaration of Conformity" can be obtained from Shure Inc. or any of its European representatives. For contact information
please visit www.shure.com
To fully interact with the Receiver, it is recommended to upgrade the UR4 firmware to 1.50 or higher and Shure Wireless Workbench to 5.0.1 or higher

LICENSING INFORMATION

Licensing: A ministerial license to operate this equipment may be required in certain areas. Consult your national authority for possible
requirements.
Changes or modifications not expressly approved by Shure Incorporated could void your authority to operate the equipment. Licensing
of Shure wireless microphone equipment is the user's responsibility, and licensability depends on the user's classification and
application, and on the selected frequency.
Shure strongly urges the user to contact the appropriate telecommunications authority concerning proper licensing, and before
choosing and ordering frequencies.
INFORMATION TO USER
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer.
Note: EMC conformance testing is based on the use of supplied and recommended cable types. The use of other cable types may
degrade EMC performance.
Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the
equipment.
MW Wireless.

Note:
20