Connecting Multiple Receivers To The Rf Distribution Ports - Shure UHF-R MW User Manual

Shure UHF-R MW Wireless
®
Network Parameters
NOTE:
The receiver reboots after you press ENTER to accept
•
network parameter changes
In dual models (MW4D+), these settings affect both
•
receivers (the dual receiver is treated as a single network
device).
Set the Receiver Network Mode
Menu: Util > Network
1. Push the Control wheel to move the cursor to the
Mode parameter.
2. Turn the Control wheel to set the receiver to one of the
following values:
DHCP: use this setting when connecting the receiver to a
•
DHCP server.
Manual: allows you to set the receiver to a specific IP
•
address or subnet.
IP Address and Subnet
Menu: Util > Network
To change these settings, the network mode
NOTE:
must be set to Manual.
1. Push the Control wheel to move the cursor to any of
the following parameters:
IP (IP address)
•
Sub (Subnet mask)
•
2. Turn the Control wheel to change the value.

Connecting Multiple Receivers to the RF Distribution Ports

The RF distribution ports pass the RF signal from one receiver to the next, allowing a maximum of 10 receivers to share a single pair of
antennas. Use the supplied RF distribution cables to connect the ports of each receiver as shown.
NOTE: All receivers must be operating in the same frequency band.
First Receiver
Additional Receivers
Last Receiver
Device ID
Assists in identifying receivers through the Wireless Workbench
Software (has no effect on network identification).
Menu: Util > Network
1. Push the Control wheel to move the cursor to the
2. Turn the Control wheel to set the receiver to change
Custom Groups
This feature allows you to create your own groups of frequencies.
Creating new groups...
Menu: Radio > Custom
1. Turn the Control wheel to select a custom group
2. Push the Control wheel to move to the Channel
3. Push the Control wheel to move to the Freq
4. Push the NEXT menu key to select a frequency for the
To Antenna B
10
DevID parameter.
the value.
number (U1, U2, U3, etc.)
parameter and turn it to select a channel (01, 02,
03, etc.)
parameter and select a frequency for that channel.
next channel in that group.
To Antenna A
Antenna A in
Antenna A in
Antenna A in
RF A out
RF A out
RF A out