Connecting Multiple Receivers To The Rf Distribution Ports - Shure UHF-R User Manual

Shure UHF-R Wireless
Network Parameters
NOTE:
• The receiver reboots after you press ENTER to accept network
parameter changes
• In dual models (UR4D+), these settings affect both receivers
(the dual receiver is treated as a single network device).
Set the Receiver Network Mode
Menu: Util > Network
1. Push the Control wheel to move the cursor to the Mode
parameter.
2. Turn the Control wheel to set the receiver to one of the
following values:
• DHCP: use this setting when connecting the receiver to a DHCP
server.
• Manual: allows you to set the receiver to a specific IP address
or subnet.
IP Address and Subnet
Menu: Util > Network
To change these settings, the network mode
NOTE:
must be set to Manual.
1. Push the Control wheel to move the cursor to any of the
following parameters:
• IP (IP address)
• Sub (Subnet mask)
2. Turn the Control wheel to change the value.

Connecting Multiple Receivers to the RF Distribution Ports

The RF distribution ports pass the RF signal from one receiver to the next, allowing a maximum of 10 single or dual receivers to share a single pair of
antennas.
Use the supplied RF distribution cables to connect the ports of each receiver as shown.
NOTE: All receivers must be operating in the same frequency band.
First Receiver
Additional Receivers
Last Receiver
Device ID
Assists in identifying receivers through the Wireless Workbench Software
(has no effect on network identification).
Menu: Util > Network
1. Push the Control wheel to move the cursor to the DevID
2. Turn the Control wheel to set the receiver to change the value.
Custom Groups This feature allows you to create your own groups of
frequencies.
Creating new groups...
Menu: Radio > Custom
3. Turn the Control wheel to select a custom group number (U1,
4. Push the Control wheel to move to the Channel parameter
5. Push the Control wheel to move to the Freq parameter and
6. Push the NEXT menu key to select a frequency for the next
To Antenna B
10
parameter.
U2, U3, etc.)
and turn it to select a channel (01, 02, 03, etc.)
select a frequency for that channel.
channel in that group.
To Antenna A
Antenna A in
Antenna A in
Antenna A in
RF A out
RF A out
RF A out