Remote Vehicle Start - Chevrolet Equinox 2010 Owner's Manual

Remote Vehicle Start

The vehicle may have this feature
that allows you to start the engine
from outside the vehicle.
(Remote Vehicle Start): This
button will be on the RKE
transmitter if the vehicle has remote
start. To enable and disable remote
start, see Remote Vehicle Start
under Vehicle Personalization on
page 4 34.
Vehicles with an automatic climate
control system will default to a
heating or cooling mode depending
on the outside temperature during a
remote start. Once the key is turned
to ON/RUN, the system will turn on
at the setting the vehicle was last
set to.
Laws in some local communities
may restrict the use of remote
starters. For example, some laws
require a person using remote
start to have the vehicle in view.
Check local regulations for any
requirements.
There are other conditions which
can affect the performance of the
transmitter, see Remote Keyless
Entry (RKE) System on page 1 3
for additional information.
Starting the Engine Using Remote
Start
To start the engine using the remote
start feature:
1. Press on the RKE transmitter.
2. Press and hold for about
two seconds. The turn signal
lamps will briefly flash to confirm
the vehicle has been started.
The parking lamps will turn on
and remain on as long as the
engine is running. The vehicle's
doors will be locked.
3. The key must be inserted and
turned to ON/RUN before
driving.
The engine will shut off after
10 minutes unless a time
extension is done or the key is
inserted and turned to ON/RUN.
I n f o r ma t i o n P r o v i d e d b y :
Keys, Doors and Windows
Extending Engine Run Time
For a 10-minute extension, repeat
Steps 1 and 2 while the engine is
still running. The remote start can
be extended once.
When the remote start is extended,
the second 10 minutes will start
immediately.
For example, if the engine has been
running for five minutes, and
10 minutes are added, the engine
will run for a total of 15 minutes.
A maximum of two remote starts or
remote start attempts are allowed
between ignition cycles.
The vehicle's ignition switch must
be turned to ON/RUN and then back
to LOCK/OFF using the key, before
the remote start procedure can be
used again.
1-5