Headlamp Aiming - Chevrolet Equinox 2010 Owner's Manual

Rear Wiper Blade Replacement
To replace the rear wiper blade:
1. Lift the wiper arm from the
liftgate glass until no further
movement is possible.
2. Hold the wiper arm at the tip with
one hand and hold the wiper
blade at the tip with the
other hand.
3. Pull down on the wiper blade.
The blade will pull away from
the arm.
4. Place the wiper blade into the
wiper arm aligning the blade
attachment rivet with the arm
attachment.
5. Align the wiper blade with the
arm and hold both ends of the
arm while gently squeezing until
the blade snaps into place.
Do not apply excessive force
during this operation.
Reposition the blade in the arm
and repeat, if blade is not
correctly positioned.
6. Place the wiper arm with the
wiper blade attached back on
the liftgate glass.
I n f o r ma t i o n P r o v i d e d b y :
Vehicle Care

Headlamp Aiming

The headlamp aiming system has
been preset at the factory.
If the vehicle is damaged in an
accident, the aim of the headlamps
may be affected and adjustment
may be necessary.
It is recommended that a dealer
adjust the headlamps. To re-aim the
headlamps yourself, use the
following procedure.
The vehicle should be properly
prepared as follows. The vehicle:
Should be placed so the
headlamps are 7.6 m (25 ft) from
a light colored wall.
Must have all four tires on a
level surface which is level all
the way to the wall.
Should be placed so it is
perpendicular to the wall or other
flat surface.
9-27