Cycle Options; Cycle Status - GE Profile DPSB650 Technical Service Manual

DELAY START
Use to delay the start of your dryer.
1. Choose your dry cycle and any options.
2. Press DELAY START. You can change the delay time in 30 minute increments using the
3. Press the START pad to start the countdown.
The countdown time will be shown in the TIME REMAINING display.
NOTE: If the door is opened while the dryer is in DELAY, the countdown time will not
restart unless the door is closed and START has been pressed again.
DAMP SIGNAL
This option causes the dryer to beep when clothes have dried to a damp level. Remove
items that you wish to hang dry. The DAMP SIGNAL will only beep when the dryer SIGNAL
is turned on.
Removing clothes and hanging them when they are damp can reduce the need to iron
some items.

Cycle Status

The cycle status indicator lights (on some models) show what part of the cycle the dryer is in and remind you to
clean the lint filter. On models without indicator lights, the cycle status will show in the display.
(on some models)
SET TIME arrow pads.
(on some models)
SENSING
This light comes on when an E
TIMED DRY
This light comes on when AIR DRY, DEWRINKLE, DRYEL
or RACK DRY is selected.
EXTENDED TUMBLE
This light comes on when the dryer is in the EXTEND TUMBLE mode.
CLEAN LINT FILTER
This light is a reminder to clean the lint filter. It comes on at the end of a cycle and
goes off when the door is opened.
T Sensor Dry Cycle is active.
ASY OUCH
(on some models), TIMED DRY
™
– 12 –