GE Profile DPSB650 Technical Service Manual page 35

Door Switch Test
Upon entering the Door Switch Test, OPn will be displayed on the DSSD if the door switch is in the open
position. If the door switch is in the closed position, CLS will be displayed.
Rod Voltage Test
Upon entering the Rod Voltage Test, the voltage of the moisture-sensing rods will be displayed in
hundredths of a volt on the SDDS. (See Sensor Rod Circuit.)
Drum Motor Test
Upon entering the Drum Motor Test, dOF will be displayed on the DSSD. Pressing START will activate
the drum motor and change the DSSD display to dOn. The dryer shall turn off the drum motor when
the Drum Motor Test has been exited.
Heater Inner Coil/Gas Valve Test
Upon entering the Heater Inner Coil/Gas Valve Test, the DSSD will display iOF, indicating the inner
heater is off (electric models) or GOF, indicating the gas valve is off (gas models).
Pressing the START pad will activate the inner heater (electric models) or the gas valve (gas models)
and activate the motor. The DSSD display will change to iOn (electric models) or GOn (gas models),
indicating that the heater or gas valve is on. The dryer shall turn off the heater/gas valve and drum
motor when the Heater Inner Coil/Gas Valve Test has been exited.
Heater Outer Coil Test (Electric Models)
Upon entering the Heater Outer Coil Test, the DSSD will display oOF, indicating the outer heater coil is
off.
Pressing the START pad will activate the outer heater (electric models) and motor. The DSSD display
will change to oOn, inidcating the heater is on. The dryer shall turn the heater and drum motor off when
the Heater Outer Coil Test has been exited.
– 33 –