Cycle Options; Damp Alert; Delay Start - GE GFDN240 Owner's Manual

About cycle options.
NOTE: Not all features are available on all dryer models.
Extended Tumble
Minimizes wrinkles by adding approximately
60 minutes of no-heat tumbling after clothes
are dry. The beeper will sound every two
minutes as a reminder to remove the clothes.
The ESTIMATED TIME REMAINING display will
show 00.

Damp Alert

This option causes the dryer to beep when
clothes have dried to a damp level. Remove
items that you wish to hang dry. The DAMP
ALERT will only beep when this option is
selected.

Delay Start

Use to delay the start of your dryer.
1. Choose your dry cycle and any options.
2. Press DELAY START. You can increase the
delay time in 1 hour increments using the
DELAY START button.
3. Press the START pad to start the
countdown.
e-DRY
Reduces the total energy consumption of
specific dryer cycles by adjusting certain
heat settings.
Note: Cycle times will change when e-DRY is
selected.
Signal
Alerts you that the cycle is complete.
The beeper will continue to sound every
minute for the next 5 minutes, until the
clothes have been removed. The clothes
should be removed when the beeper goes off
so wrinkles don't set in.
www.GEAppliances.ca
The Extended Tumble time does not get
added to the cycle time on the display
Removing clothes and hanging them when
they are damp can reduce the need to iron
some items.
NOTES:
„ If the door is opened while the dryer is
in DELAY START, the countdown time
will not restart unless the door is closed
and START has been pressed again.
This feature can be used with DELICATES,
ACTIVE WEAR, EASY CARE, NORMAL/MIXED
LOADS and COTTONS.
Press SIGNAL to select low, medium or high
volume, or to turn the beeper off.
25