Assembly - NordicTrack NTXC8018.3 User Manual

ASSEMBLY

•• Assembly requires two persons.
•• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you complete all assembly steps.
1. Make sure that the two Self-backing Nuts (71)
are inside the Front Frame (1).
Orient the Leg Bracket (2) as shown; make
sure that the indicated hole is in the position
shown.
Attach the Leg Bracket (2) to the Front Frame (1)
with two M10 x 16mm Hex Screws (73) and two
M10 Black Washers (72).
2. Insert a Leg (76) into one of the square openings
in the Leg Bracket (2).
Align the second hole from the bottom of the Leg
(76) with the indicated hole in the Leg Bracket,
and insert the straight end of a Leg Pin (74)
into the holes. Make sure that the Leg Pin
is inserted completely through the holes
and that the bent end of the Leg Pin points
toward the floor. Rotate the Leg Pin to secure it
around the Leg.
Slide an Incline Clamp (92) onto the indicated
stud and into the slots in the Leg Bracket (2).
Tighten an Incline Knob (93) and an M8 Washer
(94) onto the stud.
Attach the other Leg (76) in the same way.
•• Assembly requires the included tool(s).
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
1
1
2
72
Hole
73
2
Slots
Stud
92
94
93
76
Second Hole
5
71
72
73
2
Hole
74
76
71