NordicTrack NTXC8018.3 User Manual page 13

8. Slide the
U-bolt Cover
(64) to the
right and
check the
tightness of
the M6 Nuts
(67) on the
right side of
the Flywheel
(54). If nec-
essary, tighten the Nuts evenly with a wrench.
CAUTION: Do not overtighten the Nuts; this can
break the M6 U-bolt (not shown).
9. Slide the resistance strap back onto the flywheel.
Note: If the resistance strap is frayed on both sides,
it may be necessary to replace it. To order replace-
ment parts, see the back of this manual.
GENERAL LUBRICATION
If the front or rear
Rollers (15) begin
to squeak, a drop
of light house-
hold oil may be
needed on the
Roller Axles (70).
IMPORTANT:
The drive roll-
ers located near
the flywheel
are internally
lubricated and should NOT be oiled. Follow the
instructions below to apply oil.
1. Place a cloth or a piece of plastic under the ski
exerciser to protect your floor.
2. Put a drop of light household oil on each side of
each roller, and then spin each roller.
STORAGE
54
Set the ski resistance to the lowest setting and remove
any accessories before folding and storing your ski
exerciser. When storing the ski exerciser for more than
64
30 days, we recommend the following:
67
1. Remove the batteries from the console.
2. Slide the resistance strap off the flywheel.
3. Lightly coat the groove of the flywheel with light
4. Loosen the two adjustment knobs on the hip pad
5. Move the hip pad slide so that the top is about
Flywheel
Oil
Oil
6. Support the upper body arm with one hand. Use
70
15
7. Hold the upright with one hand. Loosen the two
8. Upon removal from storage, clean the flywheel with
13
household oil to protect the metal from corrosion.
IMPORTANT: Never place oil on the resistance
strap. Only the flywheel should be oiled and
then cleaned before the resistance strap is reat-
tached. Do not place the resistance strap on the
oiled flywheel.
slide.
seven inches below the top of the upright.
Retighten both of the adjustment knobs and pivot
the hip pad upward.
the other hand to depress the snap button on either
side of the hip pad slide. Lower the upper body arm
until it rests against the upright.
upright knobs. Lower the upright until it rests on the
base. The hip pad should just touch the tops of the
skis.
rubbing alcohol. Slide the resistance strap back
onto the flywheel.