Layout Of The Rear Panel - Swann DVR4-2000 Operating Instructions Manual

Layout of the Rear Panel

5
9 8 7 6
1) CH1 ~ CH4 (Video Inputs): These
are the four camera inputs, labelled as
per their channel in the DVR's interface.
Thus, plug the camera you want to be
associated with Channel 1 into the port
marked CH1 and so on.
2) Video Outputs: This sends a
composite video signal out of the DVR.
Each of the two ports can be connected
to separate monitors. However, there is
no requirement to use more than one
monitor/television – one usually does
the job just fine.
3) Audio Input: One RCA audio input.
This will accept standard line-level
signals (<1V).
4) Audio Output: A mono audio output
channel. These output a standard 'line-
level' signal, and can easily be connected
to the audio inputs on a television or
stand-alone audio device.
3
4 2 1
5) USB Mouse Port: For connecting
the included USB mouse (other standard
USB mice will also work). This port will
not accept a USB flash drive – this port
will work with a mouse only.
6) USB Backup Port: For connecting
a USB flash drive for the purposes of
backing up footage.
7) LAN Port: To connect an Ethernet
cable, allowing the DVR to be connected
to a local area network. This network,
in turn, can be used to give the DVR a
connection to the Internet.
8) RS485: For connecting a PTZ (pan,
tilt, zoom) capable system.
9) Power Connection: For supplying
power to the DVR. Use only the supplied
power adaptor, and do NOT change or
modify it in any way. Modifications to
your power supply radically increases
the risk of electrocution or fire, and will
immediately void your warranty.
9