Water Budget (Season Adjust); Manual - Toro DDCWP Series Installation And Operating Instructions Manual

Dial position: WATER BUDGET (Seasonal adjust)
In this dial position you can increase or decrease the
RUN TIME of all stations in that program by percentage
scaling from 0% to 200% in 10% increments.
Press PROG to select the program you wish to scale.
Press +/ON or -/OFF to change.
The Initial RUN TIME represents 100%. The controller will record the
change, i.e., if a program was scaled down to 80%, next time you enter
this dial position the display will show 80%.
To set a program to "OFF"
If you wish to stop irrigation of a program, set percentage scaling to 0%.
The display will show that program is OFF.
To resume normal operation of that program, Dial to "WATER BUDGET"
and increase the percentage to your desired value. Increasing to 100%
will set RUN TIME to its original value.
Press PROG to select the program.
Press DIAL to advance to MANUAL.
Dial position: MANUAL
The MANUAL mode allows immediate customized
irrigation on one or more zones. You can set an
individual RUN TIME for each of the stations you wish
to start manually. The controller has a "programmable manual" function, so
if you manually operate more than one station, they will open in sequence.
Press +/ON or -/OFF to set the station RUN TIME.
Press NEXT to advance to next station.
To turn ON the 1st station in the sequence:
Press DIAL to AUTO-RUN position.
Press -/OFF (in AUTO-RUN position) to turn OFF the sequence.
All stations with a manually programmed RUN TIME will be displayed.
Operating stations will flash and the display will show the remaining RUN
TIME of the station (count down).
Press DIAL to advance to MANUAL PROGRAMS.
- 8 -