Season Adjust/Adjust Water; Manual/Manual Station - Toro DDC Series Installation And Operating Instructions Manual

Dial position: SEASON ADJUST/ADJUST WATER
In this dial position you can increase or decrease the RUN TIME of all
stations in that program by percentage scaling from 0% to 200% in 10%
increments. Watering percentage is adjusted by month with
the default setting being 100% of set runtimes. This water
management feature allows you to stop irrigation for the months not requiring
irrigation and ramp up the irrigation times as the irrigation season advances.
Press PROG to select the program you wish to percentage adjust.
The display will show 1:10%. This is January, month one, and it is set at 100%.
Press "+/on" to increase watering percentage or "-/off" to decrease watering
percentage.
Press NEXT to advance to the next month. Repeat steps above to increase or
decrease watering percentage for the month displayed.
To set a program to "OFF"
If you wish to stop irrigation of a program, set percentage scaling to 0%.
The display will show that program is OFF.
To resume normal operation of that program, set dial to SEASON ADJUST and
increase the percentage to your desired value. Increasing to 100% will set
RUN TIME to its original value.
Press PROG to select the program.
Press DIAL to advance to MANUAL.
Dial position: MANUAL/MANUAL STATION
The MANUAL mode allows immediate customized irrigation on one or more
zones. You can set an individual RUN TIME for each of the stations you wish to
start manually. The controller has a "programmable manual" function, so if you
manually operate more than one station, they will open in sequence.
Press +/ON or -/OFF to set the station RUN TIME.
Press NEXT to advance to next station.
To turn ON the 1st station in the sequence:
Press DIAL to AUTO-RUN position.
Press -/OFF (in AUTO-RUN position) to turn OFF the sequence.
All stations with a manually programmed RUN TIME will be displayed. Operating
stations will flash and the display will show the remaining RUN TIME of the station
(count down). During Count Down, the seconds are not displayed until the last
minute of runtime.
Press DIAL to advance to MANUAL PROGRAMS.
-8-