P3 5 i F ireplace Insert
1 . F eed Motor
Requires no lubrication.
eep the motor windings free of dust. Can be wiped
clean or vacuumed.
To remove feed motor
•
Slide the insert body out of the mounting frame.
•
Between the feed motor and the feeder body, you ll
see the cam block with a bearing that actuates the
pusher arm.
•
With a 7 1
wrench, loosen the hex-head bolt in
the end of the cam.
•
With the bolt loosened, the feed motor and its
mounting bracket will pull straight out of the auger
shaft.
Loosen bolt in end of
cam block
2 . Combustion Blower
Requires no lubrication.
eep the motor windings free of dust. Can be wiped
clean or vacuumed.
To remove combustion blower
•
Slide the insert body out of the mounting frame.
•
Locate the combustion blower motor in the back
right corner.
•
Loosen
wing screws and turn the blower and
mounting plate 1
•
Lower the motor and paddle fan out of the blower
housing.
S a v e
T h e s e
I n s t r u c t i o n s
turn.
3 . ESP- (Ex haust Sensing Probe)
Remove and wipe clean with a soft cloth and glass
cleaner or alcohol.
To remove the probe
•
Slide the insert body out of the mounting frame.
•
The probe is installed on the side of the exhaust
chamber.
•
With a 1
attaches the probe.
•
Pull the probe out of it s mounting hole.
ESP location
3-90-775R16_08/13
socket or driver, remove the screw that
P e l l e t s o r C o r n /P e l l e t M i x t u r e O n l y
5