Harman P35i Owner's Manual page 32

d. Un-latch and remove the ash pan.
ashes in a metal container with a tight fitting lid.
e. Remove the two (2) corner cleanout covers by
removing the wing-screws (one per).
f. Brush or vacuum the remaining ash from the firebox.
g. Guide the vacuum hose upward into the exhaust
passage in the right rear corner of the firebox.
h. You can now return all pieces inside the firebox and
close the door.
V acuum or brush ex haust passage
i. Release the spring latches and slide the insert
body out onto the hearth or onto the service rail kit, if
purchased.
. Remove the exhaust chamber access cover on the
right rear of the insert.
32
P e l l e t s o r C o r n /P e l l e t M i x t u r e O n l y
k. With this cover removed, you can vacuum the
ispose of the
paddle fan and the inside of the chamber. Be careful
not to bend the blades on the paddle fan.
l. Before reinstalling the access cover, make sure the
insulation between the two layers is in tact.
6 . Inspect / Clean Hopper
F req uency: Whenever run to empty
By: User
Whenever the hopper is empty, inspect and remove
any large amounts of sawdust or fines. Although this
finer material will mostly feed through with the fuel,
large quantities of sawdust may restrict feeder flow.
- 0-775R1 08 1
P3 5 i F ireplace Insert
S a v e T h e s e I n s t r u c t i o n s