Porter-Cable TIGERCLAW 750 Instruction Manual page 9

PIVOTING GUIDE SHOE ADJUSTMENT with keyless Quik-Change™
Disconnect the tool from the power source!
Do not operate this tool with the guide shoe removed.
The Model 750 is supplied with a keyless
Quik-Change™ guide shoe. The pivoting
guide shoe (A) Fig. 11 serves as a rest
while making a cut and can be adjusted
to accommodate many types of cutting
applications.
To adjust, rotate the lever (A) Fig. 12
releasing the pivoting guide shoe (B).
Adjust to the desired position and close
the lever (A) Fig. 13. The keyless Quik-
Change™ pivoting guide shoe is designed
with a raised lip (C) Fig. 12 at the end that
prevents the guide shoe from locking in
position if it is extended out too far. After adjusting, make sure the locking lever is
completely closed in the locked position (A) Fig. 12.
NOTE: DO NOT force the locking lever closed. Adjust the shoe to allow the lever to
lock in position without force.
B
C
HOW TO HOLD THE SAW
The metal parts of the saw, blade and pivoting guide shoe may be made live if the
blade cuts into live wiring within a wall.
To prevent accidental electrical shock, hold the tool as shown in Fig.
14 or Fig.15. Make sure that the the rubber front housing cover is properly installed
and NOT DAMAGED. The rubber front housing cover also serves as an assembly pin
retention mechanism. If the cover is removed or becomes damaged, the pins can fall
out.
A
Fig. 12
Fig. 14
9
A
Fig. 11
A
Fig. 13
Fig. 15