Digital Multiplexer
CHAPTER 3. Connecting to Other Devices
This unit can be connected to other devices such as monitor, camera, VCR, and PC. This chapter
describes how to connect the unit to other devices.
CAUTIONS
Be sure that voltages higher than 2 VDC should not be input to the input terminal of Camera and Video.
1. Connecting to normal VCR and Monitor
When connecting to a normal VCR, Select 'NOR'
in "REC TYPE" of "1. REC OUT SET" in SETUP
MENU.
1. Connect a BNC cable to the VCR IN terminal
2. Connect a BNC cable to the VCR OUT terminal
3. Connect a BNC cable to the MON OUT termi-
2. Connecting to S-VHS VCR and S-VHS MONITOR
When playing back TAPE by connecting to
S-VHS, select "Y/C" in "PB IN" Mode, once
you in "2.MON OUT SET" Mode in SETUP
Menu.
1. Connect a S-JACK cable to the VCR IN
2. Connect a S-JACK cable to the VCR
3. Connect a S-JACK cable to the MON
on the Unit Rear Panel and to the OUT termi-
nal of the VCR.
on the Unit Rear Panel and to the IN terminal
of the VCR.
nal on the Unit Rear Panel and to the IN termi-
nal of the Monitor.
4-pin terminal on the Unit's Rear Panel
and to the OUT terminal on the VCR.
OUT 4-pin terminal on the Unit's Rear
Panel and to the IN terminal on the VCR.
OUT 4-pin terminal on the Unit's Rear
Panel and to the IN terminal on the
Monitor.
SDM-160M/SDM-160MP:Not used.
3-1