SDM-090(P)
Digital Multiplexer
CHAPTER 3. Connecting to Other Devices
1. Connecting to normal VCR and Monitor
This unit can be connected to other devices such as monitor, camera, VCR,
and PC. This chapter describes how to connect the unit to other devices.
CAUTIONS
Be sure that voltages higher than 2 VDC should not be input to the input terminal of
Camera and Video.
When connecting to a normal VCR, Select 'NOR' in "REC TYPE" of "1. REG
OUT SET" in SETUP MENU.
1. Connect a BNC cable to the VCR IN terminal on the Unit Rear Panel and to
the OUT terminal of the VCR.
2. Connect a BNC cable to the VCR OUT terminal on the Unit Rear Panel and to
the IN terminal of the VCR.
3. Connect a BNC cable to the MON OUT terminal on the Unit Rear Panel and
to the IN terminal of the Monitor.
VCR
OUT
IN
IN
3-1
MONITOR