Digital Multiplexer
CHAPTER 3. Connecting to Other Devices
This unit can be connected to other devices such as monitor, camera, VCR, and PC. This chapter
describes how to connect the unit to other devices.
CAUTIONS
Be sure that voltages higher than 2 VDC should not be input to the input terminal of Camera and Video.
1. Connecting to normal VCR and Monitor
When connecting to a normal VCR, Select
'NOR' in "REC TYPE" of "1. REC OUT SET" in
SETUP MENU.
1. Connect a BNC cable to the VCR IN terminal
2. Connect a BNC cable to the VCR OUT
3. Connect a BNC cable to the MON OUT
2. Connecting to S-VHS VCR and S-VHS MONITOR
When playing back TAPE by connecting to S-VHS, select
"Y/C" in "PB IN" Mode, once you in "2.MON OUT SET"
Mode in SETUP Menu.
1. Connect a S-JACK cable to the VCR IN 4-pin terminal
2. Connect a S-JACK cable to the VCR OUT 4-pin termi-
3. Connect a S-JACK cable to the MON OUT 4-pin termi-
on the Unit Rear Panel and to the OUT
terminal of the VCR.
terminal on the Unit Rear Panel and to the IN
terminal of the VCR.
terminal on the Unit Rear Panel and to the IN
terminal of the Monitor.
on the Unit's Rear Panel and to the OUT terminal on
the VCR.
nal on the Unit's Rear Panel and to the IN terminal on
the VCR.
nal on the Unit's Rear Panel and to the IN terminal on
the Monitor.
SDM-090M/SDM-090MP:Not used.
VCR
OUT
3-1
MONITOR
IN
IN
MONITOR
S-VHS VCR
OUT
IN
IN