4. Place the fan on a flat, dry, stable surface to avoid tipping over. 5. Use fan only for intended use, as described in this instruction manual.
Page 3
Carefully remove all items from the box. NOTE: It is best to have someone hold the box while you lift the fan and the protective packaging out of the carton. Make sure all shipping materials are removed from fan before operating.
This unit is suitable for grounded receptacle use only. The power cord has a grounded plug as shown in Figure 1A. The fan must be plugged into an electrical outlet that can accommodate the grounding pin. If your electrical outlet can not accommodate the...
Page 5
1. Insert Sleeve [a] into center of Wheel [b]. 3. Fasten with Large Bolt [a], Lock Washer [b], and Flat Washer [c]. 5. Insert Grey Upright Tubes [a] into Base Assembly [b]. 44805 aSSembly 2. Place the Axle [a] between the Wheel Brackets [b].
Page 6
7. Fasten Small Bolt [a] and Nylon Nut [b] using Small Allen Wrench [c] (included) and an adjustable wrench or pliers. 9. Lower the Fan Assembly [a] onto the Tubes [b] of the base assembly. Slide down until it stops.
3. Raise fan assembly slightly and release levers so they will locate in the next hole. 4. Slowly raise or lower the fan to the desired position. • The fan section can be raised and locked approx. 9" and 16" from the load carrying position.
(load carrying position). 3. This unit has been tested to carry a maximum capacity of 200 lbs. 4. For taller loads, the fan can be tilted 90 or 180 degrees to reduce load interference with the fan. FAN SPEED 1.
2. NEVER store the fan while it is still plugged in. 3. NEVER wrap the cord tightly around the fan. 4. DO NOT put any stress on the cord where it enters the fan, as it could cause the cord to break.