Section A - New Construction - Attaching To Joist - Hunter 42935-0 Installation Manual

Section A - New Construction - attaching to joist

A1
pop out a wiring access slug.
A2
5/8
1/2
position the correct depth mark at the bottom edge of
the joist based upon the the thickness of your sheetrock.
A4
Run the power supply wire through the strain relief, leav-
ing 3" between the end of the wire and the strain relief.
Tighten the strain relief around the wire.
42935-0 06/04/2007
OR
A3
5/8
1/2
A5
3"
6
Drive mounting screws (supplied) into joist or framing.
Install the wiring and the strain relief into the wiring
access hole you made earlier.