Hunter 42935-0 Installation Manual page 14

Section E - Final Installation
E2
E1
Ground
Green
A
Bare Copper
A
A
Black White
Connect the wiring as shown. Install the wiring cover box. Make sure all wiring connec-
tions are inside the wiring cover box.
NOTE: Though this final installation section shows the housing mounted to a joist, the final installation procedure is the
same whether the housing is mounted to a joist or suspended between joists.
E4
E3
Install the fan assembly by inserting the tabs as shown
Connect fan wiring harness. DO NOT ALLOW THE FAN TO
and pushing the fan assembly into the housing. Make
HANG FROM THE WIRING HARNESS.
certain the wiring is not pinched between the fan assem-
bly and the housing.
E5
E6
Secure the fan assembly by tightening the two fan
Install the strain relief bracket.
mounting screws.
42935-0 06/04/2007 4