Cortelco 8012 Instruction Manual page 15

Basic Functions
Handset Name
The 8012 handset can be given a name. This is useful if more than one handset
is registered to a base. To set the handset name:
1. Press the MENU soft key.
2. Press or
3. Press the SELECT soft key.
4. Use
or
5. Press the SELECT soft key.
6. Enter the name (up to 12 characters) using the key pad. Use the ERASE soft
key to correct any mistakes.
7. Press the SAVE soft key.
8. The handset name will display above the handset number in standby mode.
Range Alarm
Normally a beep will sound whenever the handset moves out of range of the
base. This feature may be enabled or disabled.
1. Press the MENU soft key.
2. Press or
3. Press the SELECT soft key.
4. Use or
5. Press the SELECT soft key.
6. Use or
7. Press the SAVE soft key.
8. A beep will sound to confirm.
Paging
The handset can be paged from the base. This is useful to locate a lost handset.
• To page, press the
will ring for approximately 60 seconds.
• To stop paging, press the
Note: Pressing the
registration mode.
.
(cont'd)
repeatedly to choose HS SETTINGS.
to choose HS NAME.
repeatedly to choose HS SETTINGS.
to choose TONE SETUP.
to choose ON/OFF to enable or disable the function.
key on the base. All handsets registered to the base
key again or press any key on the handset.
key for more than five seconds will put the base in
15