Telecom Requirements For Both Canada And Usa - Nortel 1535 User Manual

Regulatory and safety information
This device complies with Class B Limits of Industry Canada. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that can cause undesired operation.
The device is certified to the requirements of RSS-210 for 2.4 GHz spread
spectrum devices. The use of this device in a system that operates either
partially or completely outdoors may require that you obtain a license for
the system according to the Canadian regulations. For further information
contact your Local Industry Canada office.
Telecom requirements for both Canada and
USA
The USA and Canada telecom approvals have been obtained, however,
at this time, connection to the PSTN is not a supported feature of the IP
Phone 1535 and should not be used.
This equipment complies with Part 68 of the FCC rules and requirements
adopted by ACTA. On the bottom of the equipment is a label that
contains, among other information, a product identifier in the format US:
AAAEQ##TXXXX. If requested, you must provide this number to the
telephone company.
This equipment uses an RJ-11C modular plug to connect to the PSTN
premises wiring. A plug and jack used to connect this equipment to the
premises wiring and telephone network must comply with the applicable
FCC Part 68 rules and requirements adopted by ACTA. A compliant
telephone cord and modular plug is provided with this product. The plug is
designed to connect to a compatible and compliant modular jack.
See the installation instructions for details.
The Ringer Equivalence Number (REN) is used to determine the
maximum number of devices that can connect to a telephone line.
Excessive RENs on a telephone line can result in the devices not ringing
in response to an incoming call. In most but not all areas, the sum of
RENs should not exceed five (5.0). The REN for the IP Phone 1535 for
109