Table of Contents
Advertisement
Auto Programs
Master/Slave
Color Settings
COLORado™ Deco Quad 1 Tour User Manual Rev. 1
Auto programs allow for dynamic RGBW color mixing without a DMX controller.
1. Go to AUt.
2. Select the desired auto (A. 01~10).
You cannot edit any of the auto programs (AUTO 01~10).
The Master/Slave mode allows a group of COLORado™ Deco Quad 1 Tours (the slave
products) to simultaneously duplicate the output of another COLORado™ Deco Quad 1
Tour (the master product) without a DMX controller.
1. Set each of the slave products:
a. Go to rUN.
b. Select SLA.
2. Set the master product:
a. Set the running mode to 512 as explained in
b. Select an auto program as explained in Auto Programs above, or a static mix
of colors.
• The master product is the one that runs a program whether in Auto or Static
Color mode.
• Do not connect a DMX controller to the products configured for Master/Slave
operation. The DMX controller may interfere with signals from the master
product.
• The master product should be the first product in the daisy chain.
The CoL setting determines how the COLORado™ Deco Quad 1 Tour generates the
white color based on various RGB settings.
1. Go to the SEt main level.
2. Select COL.
3. Select oFF, rgb, or UC.
oFF:
When all the RGB faders are set to 255, the output is maximum, although
the resulting white color may not be balanced.
rgb:
When all the RGB faders are set to 255, the resulting output is defined by
the configured White color (see
UC:
When all the RGB faders are set to 255, the output matches that of less
efficient products (Universal Color).
DMX
Control.
White
Calibration).
Operation
-9-
Advertisement
Table of Contents
