Management Module Input/Output Connectors; Video Connector - IBM BladeCenter Management Module User Manual

Hide thumbs Also See for BladeCenter Management Module:

Table of Contents

v Press the IP reset button for 5 seconds, release it for 5 seconds; then; press it

Management module input/output connectors

The management module has the following I/O connectors:

v One video

v One PS/2

v One PS/2 mouse

v One 10/100 Mbps Ethernet for remote management and console

The following illustration shows the I/O connectors on the management module.

Remote management

and console (Ethernet)

Video

Mouse

Keyboard

Note: There is no internal connections between the input/output connectors on the

Your BladeCenter management module contains one standard video connector. Use

this connector to connect a compatible SVGA or VGA video monitor to the

BladeCenter unit. Blade server integrated video controllers share the

management-module video connector through the BladeCenter KVM interface.

again for 10 seconds and restart the management module to reset all of the

management-module configuration fields to the factory defaults.

keyboard

management modules when two are installed in the BladeCenter unit. See

the IBM BladeCenter Management Module Installation Guide for information

about how to cable two management modules to support the redundant

management module interface requirements of your installation.

LINK

TX/RX

Chapter 1. Introducing the BladeCenter management module

Table of Contents