Corner Check; Hoop Options - Husqvarna Viking Designer topaz 25 User Manual

20. STITCH SELECTION BUTTONS
By pressing any of the 0 to 9 buttons you select the stitch
illustrated on that button immediately.
select a stitch from 10 and up from the selected stitch menu.
If the stitch number does not exist in the selected stitch menu
as a stitch.
21/22. STEP STITCH-BY-STITCH – AND +
buttons to step through the design stitch by stitch.
23. NAVIGATOR ARROWS AND OK
your selections or changes with OK.
Use the left/right Navigator Arrows to select stitches step by
step in numerical order within the selected stitch menu.
Use the up/down Navigator Arrows to set the size of a
buttonhole and to set the number of stitches when sewing on
a button.
The Navigator Arrows are also used when programming to
select stitches/letters within the program or to select letters to
insert in the program.
In embroidery mode the Navigator Arrows are also used for
positioning the design in the embroidery area.
24/25. STEP COLOR-BY-COLOR – AND +

26. HOOP OPTIONS

Press the Hoop Options button to open a list where you can
27. ROTATE DESIGN
Press the Rotate button to rotate current design 90 degrees
28. EMBROIDERY INFO BUTTON
Press this button before loading a design to see information
about design size, number of colors and stitches. Press this
button with a design loaded to embroidery mode to see design
page 70.
29. SET MENU
Press to open the menu for machine settings. Make changes

30. CORNER CHECK

In embroidery mode, press the Corner check button to trace
the four corners of the design. Each time you press the button
– and +
31. EXCLUSIVE SEWING ADVISOR
sets the best stitch, stitch length, stitch width, thread tension,
sewing speed and sensor foot pressure for your project. The
stitch is displayed on the GraphicDisplay with presser foot
and needle recommendations. Press the symbols for the fabric
– and +
™
feature automatically
™
S & F
ETTINGS UNCTION BUTTONS
29