Winding The Bobbin Using The Auxiliary Spool Pin; Inserting The Bobbin - Husqvarna Viking Designer topaz 25 User Manual

WINDING THE BOBBIN USING
THE AUXILIARY SPOOL PIN
1. Place an empty bobbin on the bobbin spindle on the top
bobbins.
®
felt pad under the spool.
3. Bring the thread over and behind the pre-tension thread
the inside to the outside.
5. Push the bobbin spindle to the right. A pop-up message
appears on the GraphicDisplay. Hold the end of the
to start winding. Once the bobbin begins to wind, cut the
excess thread. When the bobbin is full it will stop rotating.
Release the foot control. Push the bobbin spindle back to
the left, remove the bobbin and cut off the thread on the
thread cutter.

INSERTING THE BOBBIN

Press the ON/OFF switch to "O".
1. Remove the bobbin cover by sliding it towards you.
2. Place the bobbin in the bobbin case. It drops in only one
way with the logo facing up. The thread unreels from the
left of the bobbin. The bobbin will then rotate counter-
clockwise when you pull the thread.
A
B
1.
F
E
G
3.
D
C
2.
I
H
4.
S U
ET P
19