Bobbin Winding - Vertical Spool Pin; Placing The Bobbin In The Machine - Husqvarna Viking Prelude 350 User Manual

Bobbin Winding – Vertical
Spool Pin
1. Place an empty bobbin with the mark
out-wards on the bobbin spindle and bring it
down.
2. Place the large spool holder under the thread
on the spool pin.
3. Bring the thread under the thread guide (a)
and over thread guide (b), further under thread
guide (c).
4. From above wind a few turns of thread
around the bobbin and into the knife.
5. Press the foot control. When the bobbin win-
ding is fi nished, remove the bobbin, cut off
the thread and bring the bobbin spindle up.
Placing the Bobbin in the
Machine
Turn off the main switch.
1. Remove the bobbin cover by sliding it towards
you.
2. Place the bobbin in the bobbin case with the
mark facing up and the thread to the left
of the bobbin. The bobbin will then rotate
counter clockwise while pulling out the thread.
3. Place your fi nger on the bobbin to keep it
from turning as you pull the thread fi rmly to
the right and then to the left into the tension
spring (a) until it ''clicks'' into place.
4. Continue threading around (b) and to the right
of and then left into the thread cutter (c).
Replace the cover (1). Pull the thread to the left
to cut it (2).
8
Procedures
a
b
c
b
b
a
c
2
1