1
►
Push the board into the slot (1).
►
Press the board into the slot so that it engages.
►
If necessary, connect the cables.
2
2
►
Press the clips (2) from outside in the cut-outs on the case rear panel until the clips engage.
When doing so, make sure that you press the rail carrier (a) into the corresponding opening.
►
Fold closed the locking slide (3).
►
If you have removed the cross-piece, install it now (see "Installing the cross-piece").
►
Install the fan (see "Installing the side fan").
►
Close the casing (see "Closing the casing").
A26361-K994-Z220-1-7619, Edition 2
a
3
System upgrades
55