Off-Hook Voice Announce; Placing External Calls - Mitel 8660 User Manual

Answering and Placing Calls

Off-Hook Voice Announce

Off-Hook Voice Announce
speakerphone, even though the user already has a call in progress on the handset.
NOTE
To use Off-Hook Voice Announce:

Placing External Calls

The following sections describe features used when placing external calls.
To place an external call:
1. Press the OUTGOING button, an unlit CALL button, or enter the Outgoing Call access
2. Dial the number.
Depending on system configuration, you may also be able to use one of the following methods
to select an outgoing line:


Contact your system administrator for more information about using Select Line Group or ARS
access codes.
2.
Page 24
2
allows you to talk to the phone user on his or her handsfree
This feature is not available on the 8660 IP Phone.
Do not hang up. After the busy signals stop, you are automatically connected and may
speak. (If you hear music or if the phone is in DND mode, your off-hook voice announce
call will not go through.) This feature is not available if your phone has the Ring Intercom
Always feature enabled.
code (the default code is 8).
If you cannot place an external call because all outgoing lines are busy, you
can request a callback, which prompts the system to contact you when a line
becomes available. See "Requesting a Callback (Queuing the Phone)" on
page 23.
NOTES
If you are prompted for an account code (indicated by a single beep), you
must enter an account code before you can place your call. See "Using
Account Codes" on
Enter the Select Line Group feature code. The default codes are 92001 to 92208.
Enter the Automatic Route Selection (ARS) feature code. The default code is 92000.
Applies to 8560 Telephones only. This feature may or may not be enabled for your system.
page 29.
Mitel ® 8560/8660 Phone User Guide – Issue 15, February 2011