Sanyo SCP-3200 User Manual page 38

Adjusting the Phone's Volume Settings
Adjusting the Ringer Volume
1.
Select
2. Adjust the volume level with the navigation key and press Done
(left softkey).
When adjusting the volume, press
the box next to Always Vibrate. This setting makes the
ringer vibrate at any volume level.
Tip:
You can adjust the ringer volume in standby mode (or the earpiece volume
during a call) by using the Side Volume key.
Adjusting the Alert Volume Settings
This setting controls the alert volume of Push 2 Talk,Voicemail,
Messaging, and Calendar/Alarm. You can set the alert volume
separately from the ringer volume setting.
To adjust the alert volume setting:
1.
Select
Select Push 2 Talk, Voicemail, Messaging, or Cal./Alarm.
2.
3. Using the navigation key, select Separate Vol.
4. Adjust the volume level with the navigation key and press Done
(left softkey).
Adjusting the Phone's Receiver Volume
1.
Select
Select either Earpiece or Speaker.
2.
3. Adjust the volume level with the navigation key and press Done
(left softkey).
Adjusting the Application, Start-up/Power-off, or Key Beep
Volume
1.
Select
2. Select Application, StartUp/PwOff, or Key Beep.
Adjust the volume level with the navigation key and press Done
3.
(left softkey).
32 4. Your Phone's Settings
> Settings > Sounds > Volume > Ringer.
> Settings > Sounds > Volume> Advanced Ring.
> Settings > Sounds > Volume > Receiver.
> Settings > Sounds > Volume.
to put a check mark in