Sanyo SCP-3200 User Manual page 115

Making a Push 2 Talk Call (Group Call)
You can make a Push 2 Talk call to all members in a Group entry,
which you have in your Push 2 Talk List. You can communicate with
up to five members at a time.
1.
Press
2. Press Go to (left softkey) > Personal Grps.
3.
Highlight the group entry you want to call, and press and hold
to place the call and take the floor. (You will see
"P2T calling..." and "Connecting..." followed by "You have floor."
Continue with the Push 2 Talk call as described previously.)
To make a Push 2 Talk call to a group member, select your
desired group, highlight your desired group member, and
press and hold
If one of the group members takes the floor, you will see the
member's name and Push 2 Talk number on the display.
4.
When the call is finished, press
Tip:
The phone beeps if you press
You can also make a Group Call after checking the group member.
Press to display group members, highlight
hold during step 3 above.
To redial your last Push 2 Talk call, highlight
Push 2 Talk List.
Making a Push 2 Talk Call by Entering a Number
1.
From standby mode, enter the Push 2 Talk number you want to
dial.
2.
Press
3.
Continue with the Push 2 Talk call, pressing and holding
to speak and releasing it to allow other parties to reply.
4.
When the call is finished, press
– or –
1.
Press
2. Press Go to (left softkey) > Enter P2T#.
3.
Enter the Push 2 Talk number you want to dial.
4.
Follow steps 2-4 above.
Note:
Push 2 Talk numbers must contain a 9-11 digit phone number. Your Push 2
Talk number is the same as your phone number.
to access the Push 2 Talk List.
.
to place the Push 2 Talk call.
to access the Push 2 Talk List.
.
when another party has the floor.
<Call Group>
and press
Redial
.
12. Push 2 Talk
and press and
from the
109