Framing The Heater - Heat & Glo 6000TRSI-AUC Installation And Operation Instructions Manual

B. Framing the Heater
Framing can be built before or after the heater is set
in place. Framing should be positioned to
accommodate wall coverings and heater facing
material. The diagram below shows framing reference
dimensions.
B*
A
WALL
STUD
86 mm
FIGURE 1.3 Framing Dimensions
6
Framing should be constructed of
2 X 4 lumber or heavier.
C
76 mm
NON-COMBUSTIBLE ZONE
IS DEFINED BY 76MM ABOVE
THE ELBOW FOR THE ENTIRE
WIDTH AND DEPTH (BEHIND
THE FRONT HEADER) OF
THE FIREBOX.
Heat & Glo • 6000TRSI-AUC • 2078-900 Rev.C • 7/06
CAUTION: MEASURE HEATER DIMENSIONS AND
VERIFY FRAMING METHODS AND WALL COVER-
ING DETAILS, BEFORE FRAMING CONSTRUC-
TION BEGINS.
The framing
headers may rest
on the heater
standoffs.
A B C
42-1/8 in. 38-19/32 in. 22-1/16 in.
(1070mm) (980mm) (560mm)
* NOTE: Dimension B taken from finished
hearth frame. Dimensions D and E taken
from bottom of unit.
E*
D*
D E
26-7/8 in. 47-3/4 in.
(684mm) (1060mm)