Electrolux Diva Service Manual page 36

7.3 Service function / manufacturing test routine:
General information
w Calling the service functions is executed in all designs
resp. key arrangements analogously.
w For that you always have to use keys S0, S1, S2 and S3
independent of their variant-depending program load.
w In the service function mode the key S3 is ALWAYS
responsible for calling the "manufacturing test routine".
LD1 S1
1 99
Tastenanordnung
LD2 S2
waagrecht
LD3 S3
LD1 LD2 LD3
1 99
Tastenanordnung
senkrecht
S1 S2 S3
It is generally valid:
For calling all service functions you always have first
to actuate the function keys S1 and S3 before switching
on the appliance by ON/OFF switch S0!
The keys have to remain pressed about 4 seconds to
activate the function.
This procedure is intentionally different to that for the
customer functions.
Calling above-mentioned service function
1.
LD1
LD2
LD3
blinken
2.
LD1
Tasten S1/S3
LD2
für ca. 4 Sek. halten
bis LD1-LD3 blinken!
LD3
LD0
blinkt
3.
S1
LD3
LD0
blinkt
4.
S0
LD3
Fertigungsprüfprogramm
Calling the function "manufacturing test routine"
LD0
S1
S3
S0
LD0
S1
S3
S0
LD0
S0
S3
LD0
21 Laufzeit
S3
S0
läuft ab
From that moment the same input philosophy is valid for the
manufacturing test routine as for normal washing cycles.
36
1. Press keys S1 and S3 simultaneously and ...
2. ... and switch on the appliance by ON/OFF switch S0.
For that keep the keys S1 and S3 pressed simutaneously
until the 3 confirmation LEDs LD1, LD2 and LD3 are flashing.
3. By actuating the function key S3 you can call the
manufacturing test routine.
The key LED LD3 continues flashing, the LEDs LD1 and LD2
go out.
4. The test routine starts automatically.
The run time LED flashes up.
The display indicates the expected run time.
F
cycle run and cyle end
(see description page B 5 )
F
delete cycle in advance
(see description page B 6 )
F
interrupt program
(see description page B 8 )