Electrolux Diva Service Manual page 32

6.12 Customer function / deactivation of rinse-aid addition
General information
The function rinse-aid deactivation does not exist generally
and must be programmed in the software variant.
w The deactivation resp. activation of the rinse-aid addition is
executed in all designs resp. key arranements analogously.
w For that you always have to use keys S0, S1, S2 and S3
independent of their variant-depending program load.
w Key S2 is ALWAYS the "rinse-aid deactivation key"
w The rinse-aid addition is always set active by the manufacturer.
w If the rinse-aid addition is deactivated it means that no
no more rinse-aid is added via the detergent dispenser.
Along with the deactivation, a variant-depending existing
rinse-aid LED is also deactivated generally.
LD1 S1
1 99
Tastenanordnung
LD2 S2
waagrecht
S3
LD3
LD1 LD2 LD3
1 99
Tastenanordnung
senkrecht
S1 S2 S3
Calling / changing / saving the rinse-aid addition deactivation
1.
LD1
LD2
LD3
2.
LD1
LD2
LD3
3.
LD2
4.
LD2
5.
LD0
LD2
S1
LD0
S0
LD1 S1
LD2 S2
LD3 S3
... AUS nach 60sek. automatisch
LD0
S1
S2
S3
S0
blinken
LD0
S2
S0
S3
blinken
LD0
1d
S2
S0
blinken
LD0
0d
S2
S0
blinken
LD0
1d
S2
S0
LD0
S1
LD0
LD1 S1
LD2 S2
LD3 S3
S0
... AUS durch manuelle Betätigung über Ein/Aus
32
When calling the customer functions no washing cycle
must be selected generally!
Calling the function "deactivate rinse-aid addition"
Switch on appliance with ON/OFF key S0
1.
2. Press keys S2 and S3 simultaneously until the
confirmation LEDs LD1, LD2 and LD3 are flashing.
3. By actuating the function key S2 you now can call the
function rinse-aid addition. The confirmation LED LD2
continues flashing, LEDs LD1 and LD3 go out.
The current condition whether the rinse-aid addition is
active or not is indicated in the display.
1d = rinse-aid addition on / 0d = rinse-aid addition off
Deactivation resp. activation of rinse-aid addition:
4. / 5. By any further actuation of the function key S2 you activate
resp. deactivate the addition alternating.
Leaving the function
After pressing the function key S1 last you can leave the
special program as follows:
After 60 seconds all displays go out automatically, except
LD0 of the ON/OFF key
or
the appliance is switched off by ON/OFF key S0.
Saving the set condition
The condition is saved directly after any entry.