Table of Contents
Advertisement
CDM-600L Satellite Modem
Front Panel Operation
See the Chapter 11 EDMAC operation specified in this manual.
6.3.1.9
CONFIG: MISC
MISC:
ADPCM-AUDIO-VOLUME
Select the parameter to edit using the [←] [→] arrow keys, then press ENTER.
CONFIG: MISC: G.703 CODE
Tx G703/DDO CODE = AMI
Rx G703/IDI CODE = AMI
Parameters may only be edited if the Interface Type is G.703.
Use the [←] [→] arrow keys to select the parameter to edit. Select either appropriate
G.703 code using the [↑] [↓] arrow keys, then press ENTER.
Note that the choices displayed here will depend on the G.703 interface type which has
been selected. The choices are:
•
•
•
CONFIG: MISC: IDR-ESC-TYPE
TX–IDR-TYPE: 64k DATA (64k DATA,AUDIO)
RX-IDR-TYPE: 64k DATA (64k DATA,AUDIO)
Parameters may only be edited if the Interface Type is G.703.
Parameters may only be edited if the Framing Mode is IDR.
An EDMAC MASTER is a unit which is local to the M&C computer, and which
passes messages, via the overhead, to a distant-end modem. The MASTER address
will always end in 0.
An EDMAC SLAVE is a unit which is not local to the M&C computer, which is at
the distant-end of a satellite link. The SLAVE EDMAC address will always end
in 1.
G.703-LINE-CODE IDR-ESC-TYPE
HDB3 (for E1 and E2 operation)
B8ZS ( for T1 and unbalanced T2 operation)
B6ZS (for balanced T2 operation)
HIGH-RATE-ESC
(AMI,B8ZS)
(AMI,B8ZS)
6–22
Revision 2
MN/CDM600L.IOM
Advertisement
Table of Contents
