Table of Contents
Advertisement
CDM-600L Satellite Modem
Remote Control
Command
Arguments
(Instruction
for Command
Parameter
Type
Code and
or Response
Qualifier)
Retrieve next 5
N/A
80 bytes
unread Stored
Events
Clear All
CAE=
None
Stored Events
Initialize
IEP=
None
Events Pointer
Description of Arguments
to Query
Query only.
Unit returns the oldest 5 Stored Events which have not yet been
read over the remote control. Reply format: [CR]Sub-
body[CR]Sub-body[CR]Sub-body[CR]Sub-body[CR]Sub-body,
where Sub-body= ABCddmmyyhhmmss,
A being the fault/clear indicator.
F=Fault
C=Clear
I=Info
B being the fault type where:
1=Unit
2=Rx Traffic
3=Tx Traffic
4=Power on/off, or log cleared
5=Open Network
C is Fault Code number, as in FLT? or
Info Code, which is:
0=Power Off
1=Power On
2=Log Cleared
3=Global Config Change
4=Redundancy Config Change
If there are less than 5 events to be retrieved, the remaining
positions are padded with zeros.
If there are no new events, the response is RNE*.
Command only.
Forces the software to clear the software events log.
Example: CAE=
Note: This command takes no arguments
Command only.
Resets internal pointer to allow RNE? queries to start at the
beginning of the stored events log.
Response to
Command
N/A
CAE=
CAE?
CAE*
CAE#
IEP=
IEP#
16–25
Revision 2
MN/CDM600L.IOM
Query
(Instruction
Response to Query
Code and
Qualifier)
RNE?
RNE=[CR]ABCddmmyyh
hmmss[CR]ABCddmmyyh
hmmss[CR]ABCddmmyyh
hmmss[CR]ABCddmmyyh
hmmss[CR]ABCddmmyyh
hmmss
(see description for details
of arguments)
N/A
N/A
N/A
N/A
Advertisement
Table of Contents
