Stove Leg Installation; Pedestal Installation; Using Outside Air With The Pedestal - Lopi Parlor Owner's Manual

Stove Leg Installation -

•
Raise the stove 8" (use lumber). Attach each leg following the instructions below.
Attach each leg to the stove by
inserting a bolt and washer through the
hole or slot in the leg and into the
threaded hole on the stove.
These rubber-tipped bolts are for leveling the stove.
Make sure they contact the floor. Do not adjust
with weight on the legs, the rubber tips may tear.
Pedestal (Part # 99200106)
If using outside air with the pedestal, follow the directions below under "Using Outside Air with the
Pedestal" prior to installing the pedestal.
Use a 9/16" wrench to attach the two
pedestal bolts to the bottom of the stove.
9/16" Socket Wrench
The screen, insulation, cover plate,
and staples are used for outside
air.

Using Outside Air with the Pedestal

Before installing, check the section "Outside Air Requirements" 11 for installation concerns.
1. Determine the location of the outside air hole penetrating the floor (& hearth). The illustration
above details the size of pedestal and its location in relation to the stove. The hole may be cut
anywhere underneath the pedestal, as long as it is not within 2" of the outside perimeter of the
pedestal, is at least 16 square inches in area, and does not interfere with structural members of
the home. Place the rodent screen over the hole (above or below) and secure with staples.
2. Attach the stove to the pedestal with the included bolts. Tuck the included insulation underneath
the side edges of pedestal to seal off any air from entering underneath the pedestal.
3. Install the cover plate following the directions below (use the cover plate that is 6-1/2" wide). The
cover plate prevents combustion air from entering the front of the stove.
© Travis Industries
Optional Equipment
Brass # 99200500, Cast Black # 99200800, Black Steel # 99200100
23-5/8"
Remove the two screws on the
cover plate to remove the piece that
fits over the air control rod. Then
replace the piece when the cover
plate is in place.
Stove
Pedestal
16-1/4"
Air Control Rod
The cover plate has a clip which attaches
it underneath the air control.
100-01141
9/16" Socket Wrench
The lag bolts
and washers
may be inserted
through the
holes in the
base of the
pedestal to
anchor the
pedestal to the
floor.
NOTE: when attached, the
stove front is flush with the
front of the pedestal.
33
4040923