Lopi Parlor Owner's Manual page 32

32
3 Attach the retainer to the shell following the directions below.
1/8" Hex Wrench
Once the door is aligned, tighten
the two set screws on the bottom
of the door shell to secure the
door retainer.
4 Attach the door handle
following the directions to
the right.
5 Replace the door on the
hinges and latch the door.
6 Attach the ashlip trim
following the directions
below.
1/16" Hex Wrench
© Travis Industries
Optional Equipment
Make sure the door retainer is centered on the door shell.
You can gauge the alignment by looking at the gaps here.
Slide the ashlip trim into place then tighten the three
set screws on the bottom of the ashlip to secure.
100-01141
NOTE: in rare cases the door retainer may not line up with
the door shell, preventing the door handle from lining up
correctly. To adjust the position horizontally, loosen the set
screws (see step 3) and adjust the door retainer position. To
adjust vertically, remove the retainer and adjust the clips on
the door shell (see step 2).
9/16" Wrench
4040923