Power Cord Storage; Maintenance - Bissell 3108 SERIES User Manual

Emptying The Dirt Cup Continued
If the surface of the Filter looks dirty or discolored, clean or
3.
replace it. To clean the Filter, remove any debris still clinging to
it. You may also wash the Filter (#32047 only) by gently rinsing
under warm running water. Be sure the Filter is completely dry
before replacing it in your Easy Vac. After a time, it will be
necessary to purchase replacement Filters.
Replace the Filter in the Dirt Cup pushing down tightly to
4.
ensure gasket is in place. Place the small tab on the bottom of
the Cup into the bottom of the canister cavity. Press the upper
portion of the cup until the lock button snaps into place.

Power Cord Storage

When you are done using your BISSELL Easy Vac PowerBrush,
store the Power Cord.
Turn Easy Vac PowerBrush off by moving switch to
1.
"Off" position.
Unplug Power Cord by grasping the polarized plug (NOT the
2.
cord) and disconnect from outlet.
Loop Power Cord around Cord Wraps on side of cleaner,
3.
making certain Quick Release Cord Wrap is pointed up
towards Handle.
Clip molded plug to Power Cord to secure.
4.

Maintenance

To maintain maximum performance from your
Easy Vac PowerBrush, perform these simple
maintenance checks weekly:
8
Check the debris level in the Dirt Cup and empty
if necessary.
Check the Filter for damage. Remove debris and
wash or replace as needed.
Check Rotating PowerBrush and remove any
strings, hair or debris
Upper Cord Wrap
Lower Cord Wrap
Tip:
Vacuuming
new carpet or
vacuuming fine
powders such as
drywall dust may
clog the filter, so
check it more
frequently. Shake
out or replace
as necessary.
WARNING:
To reduce the risk of
injury from moving parts
and/ or electrical shock,
turn Power Switch OFF
and disconnect polarized
plug from electrical out-
let before performing
troubleshooting checks.