Table of Contents
Advertisement
Operati s
Power cord storage
1. Turn Vacuum off (O).
2. Unplug power cord by grasping the polarized
plug, NOT the cord, and disconnect from outlet.
3. Loop power cord around cord wraps on the handle.
4. Clip molded plug to power cord to secure.
Main n ce
& Care
Emptying the dirt container
1. Turn Vacuum off (O).
2. To remove dirt from the dirt container and
filter, hold the vacuum vertically as shown.
Depress and hold latch on top of the vacuum
to release the dirt container.
3. Gently pull dirt container away from the hand
vacuum grip and remove the filter as shown.
Empty into waste container.
4. The dirt container may be rinsed with warm
water and a mild detergent if needed. The dirt
container must be thoroughly dried before
replacing.
5. Replace filter. Attach dirt container to
vacuum by depressing latch and securely
fitting onto hand grip. Make sure dirt container
is correctly secured.
Cleaning the filter
The key to maximum performance is having
clean filters. Cleaning the filters after each use
will help your 3-in-1 vacuum operate at peak
efficiency.
Use only BISSELL replacement filters in your
BISSELL 3-in-1 vacuum.
1. Turn Vacuum off (O).
2. Follow the steps on page 5 to remove
dirt container and main filter. To clean
the main filter, shake over a waste
container until debris is gone. Place
the filter back into the dirt container.
NOTE: After heavy usage, you may clean the
filter by washing it gently by hand in warm
water and mild dish detergent. Rinse
thoroughly and make certain it is completely
dry before replacing it. If filter is torn, replace
it with a new filter.
3. Attach dirt container to vacuum by depressing
latch and securely fitting onto hand vacuum grip.
Make sure dirt container is correctly secured.
WARNING
To reduce the risk of electric shock, turn power switch o
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
2.
3.
5.
2.
www.BISSELL.ca
5
Advertisement
Table of Contents
