Power Switch - Bissell 3108 SERIES User Manual

How To Put It Together Continued
Attach PowerBrush Cord to Canister
3.
Plug cord attached to Floor Nozzle into back of canister.
Attach Crevice Tool to Tool Clip
4.
Slide narrow end of Crevice Tool over angled post on the
side of the Canister, then press round end of Tool into
semi-circular grip located just below the Quick Release
Cord Wrap.
EASY VAC PowerBrush assembly is now complete.
How to use your BISSELL Easy Vac PowerBrush
Power Cord Quick Release
Remove the plastic plug guard and dispose.
1.
Unclip polarized plug from Power Cord.
2.
Rotate the Upper Cord Wrap towards floor
3.
and slip Power Cord from Upper and Lower
Cord Wraps.
Connect Power Cord Plug to a polarized outlet.
4.
To keep the Power Cord out of your way while cleaning,
5.
place it in the Cord Hook at the top/back of the handle.

Power Switch

The Power Switch is located just above the Canister
Handle. Use one of three settings.
Bare Floor - use this setting to turn off the rotating
Carpet PowerBrush- use this setting to turn on the
Off - Turn off the vacuum when cleaning is complete
6
PowerBrush if desired for bare floors
rotating PowerBrush for carpeted
surfaces
Upper Cord Wrap
Lower Cord Wrap
Tip:
Before cleaning
under low furni-
ture, check for
objects that
might block the
vacuum hose. Do
not pick up hard
or sharp objects
such as glass,
nails, screws,
coins, paper
clips, etc.