Inserting The Device In The Mounting Cup; Removing The Device; Removing The Suction Cup Holder; Switching On/Off - Blaupunkt TravelPilot 100 Instructions Manual

Installation in the vehicle | Switching on/off
Inserting the device in the mounting
cup
The device features 2 recesses on the underside
and one recess on the rear side for the mounting
cup.
u
Place the device onto mounting cup with the
underside fi rst and push it to the back.
The clamping holder of the mounting cup
must engage in the rear side of the housing
with a click.
u
Align the bracket.

Removing the device

u
Push the clamping holder down.
The device disengages from the bracket.
u
Remove the device.

Removing the suction cup holder

If you change vehicles, you can simply remove the
support.
u
Push the lever on the support away from the
glass.
u
Carefully loosen the suction cup at the edge
from the glass so that air can enter between
suction cup and glass.
u
Carefully pull the suction cup off of the glass.
8

Switching on/off

The On/Off switch is used to switch the device
on and off.

Switch-on

u
Press and hold the On/Off switch for longer
than 3 seconds.

Switch-off

u
Press and hold the On/Off switch for longer
than 3 seconds.
The device is fi rst placed in idle state and
remains ready for operation. All functions will
be completely switched off after 20 minutes.
Note:
The device continues to use a small amount of
energy even if it is switched off. If you use the
device again after an extended period of time,
it may be necessary to recharge the battery.

Reset

If the device does not work properly, a simple
reset may help.
u
Press and hold the On/Off switch for longer
than 14 seconds.
The device is switched off and restarted.