Rainbow2 Quick Start Guide 1. Installation and access Connection Set up Rainbow2 as below: Stand bracket installation instruction A. Put the bottom side of the IP phone upside and press one-side joints of stand bracket into the slot, please refer the picture as below:...
Page 4
Rainbow2 Quick Start Guide B. Press the other side joints into the slot according to the direction of the arrow: C. It is the right picture after fixing the stand bracket below: ATCOM TECHNOLOGY CO., LIMITED...
Page 5
Rainbow2 Quick Start Guide D. Disassemble the stand bracket: Push the spring joint of stand and pull the stand according to the direction of the arrow. When the joints are pulled out of the slot, you can take off the stand bracket ATCOM TECHNOLOGY CO., LIMITED...
Rainbow2 Quick Start Guide Programmable keys’ paster using instruction Step1. Use needle or some other tools to insert into the hole of the plastic sheet, hog the plastic sheet. Step2. Lift out the plastic sheet Step3. Take off the plastic sheet Step4.
Steps to use Rainbow E’s paster are the same as programmable keys’ as below: Check IP Rainbow2 uses DHCP mode by default, and you can review its current IP address by pressing key when it is powered on and connected to the network.
Network mode: you can choose DHCP, Static and PPPoE DHCP: Rainbow2 default to use DHCP to obtain IP from DHCP Server. Static: If you want to set the IP as static, you should fill IP, Netmask, ...
SIP Server. Enable: whether enable this SIP register. Display Name: This name will display on the screen of Rainbow2. It will display the name configured for the SIP account by the SIP server preferentially. It can also be kept blank.