Assembly - Delta ShopMaster MS275 Instruction Manual

UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from
all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone,
gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household
floor paste wax.
ASSEMBLY TOOLS REQUIRED
* Phillips head screwdriver (not supplied)
ASSEMBLY TIME ESTIMATE - 15 to 30 minutes
For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
B
Fig. 2
ROTATING THE TABLE
Loosen the table-lock handle (A) Fig. 2 one or two turns. Raise the index lever (B) Fig. 2 and rotate the table to the
desired position. Tighten the table-lock handle (A) Fig. 3.
MOVING THE CUTTINGHEAD TO THE "UP" POSITION
DISCONNECT THE MACHINE FROM THE POWER SOURCE.
1. Push the switch handle (A) down and pull out the
cuttinghead lock knob (B).
2. Move the cuttinghead (C) to the up position.
3. To lock the cuttinghead in the "down" position, reverse
the procedure.

ASSEMBLY

A
A
A
B
Fig. 4
8
Fig. 3
C