Planet SGSW-24040 User Manual page 159

 Point2Point
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
By default, the system automatically detects the speed and duplex mode used on each port, and configures the path cost
according to the values shown below. Path cost "0" is used to indicate auto-configuration mode. When the short path cost
method is selected and the default path cost recommended by the IEEE 8021w standard exceeds 65,535, the default is set to
65,535.
Port Type
Ethernet
Fast Ethernet
Gigabit Ethernet
Port Type
Ethernet
to the similar bridge setting, the port Edge status does not effect this setting.
A port entering error-disabled state due to this setting is subject to the bridge Port
Error Recovery setting as well.
Controls whether the port connects to a point-to-point LAN rather than a shared
medium. This can be automatically determined, or forced either true or false.
Transitions to the forwarding state is faster for point-to-point LANs than for
shared media.
(This applies to physical ports only. Aggregations are always forced Point2Point).
Port Type IEEE 802.1D-1998
50-600
Ethernet
10-60
Fast Ethernet
3-10
Gigabit Ethernet
Table 4-7-1 Recommended STP Path Cost Range
Link Type
Half Duplex
Full Duplex
Trunk
Half Duplex
Full Duplex
Trunk
Full Duplex
Trunk
Table 4-7-2 Recommended STP Path Costs
Link Type
Half Duplex
Full Duplex
Trunk
User's Manual of SGSW-24040 / 24240 Series
IEEE 802.1w-2001
200,000-20,000,000
20,000-2,000,000
2,000-200,000
IEEE 802.1D-1998
100
95
90
19
18
15
4
3
IEEE 802.1w-2001
2,000,000
1,000,000
500,000
138
IEEE 802.1w-2001
2,000,000
1,999,999
1,000,000
200,000
100,000
50,000
10,000
5,000