Table of Contents
Advertisement
Periodic maintenance and adjustment
1. V-belt
6.
Remove the V-belt from the secondary
sheave assembly and primary sheave
assembly.
7.
Temporarily install the new V-belt on the
secondary sheave assembly only, and
then measure the V-belt position. Do not
force the V-belt between the sheaves; the
secondary sliding and fixed sheaves
must touch each other.
2
1. Edge of the secondary sheave assembly
2. Standard V-belt position
90
Standard V-belt position:
From 1.5 mm (0.06 in) above the
edge of the secondary sheave as-
sembly to 0.5 mm (0.02 in) below the
edge
8.
If the V-belt position is incorrect, adjust it
by removing or adding a spacer on each
V-belt position adjusting bolt.
1. V-belt position adjusting bolt
2. Spacer
1
V-belt position
More than 1.5 mm
(0.06 in) above the
edge
From 1.5 mm (0.06 in)
above the edge to 0.5
mm (0.02 in) below
the edge
More than 0.5 mm
(0.02 in) below the
edge
Adjustment
Remove a spacer.
Not necessary (it is
correct).
Add a spacer.
Advertisement
Table of Contents
